Minelab Manticore Panel Housing
Protective case designed for the Minelab Manticore detector panel . Made using 3D printing technology.
Protects the control panel against dust, mud, rain, dirt and scratches .
The case has a two-stage display protection , including an additional layer with increased scratch resistance.
The set also includes a sun visor that reduces light reflection from the display and improves its readability when working on sunny days.
The buttons are designed to be easy to operate and not interfere with the detector's operation . The side buttons are made of rubber.
The housing also has a rubber cover for the charging port that protects it from dust, mud and other dirt.
The design is lightweight – the complete housing weighs approximately 97 g .
Installation is done with 6 screws and takes about 30 seconds .
Key features:
- made using 3D printing technology,
- designed for Minelab Manticore,
- two-stage display cover,
- one of the covers is scratch-resistant,
- sun visor,
- protection against dust, mud, rain and scratches,
- easy-to-use buttons,
- rubber side buttons,
- rubber charging port cover,
- weight about 97 g,
- simple and quick assembly with 6 screws.
Included in the set:
- Minelab Manticore housing,
- sun visor,
- rubber charging port cover,
- set of mounting screws.
The housing is not waterproof. It protects the panel from rain and splashes, but is not intended for submersion in water.
Due to the design of the housing, it was not possible to retain the button backlight function . After installing the housing, the buttons still function fully, but their factory backlighting is no longer visible.
This product is made using 3D printing. Visible layers and minor differences in surface structure are a natural feature of this technology and do not constitute a product defect.
|
